Форумы Якутск Онлайн - Где в нашем городе продают Xbox360?

Flashing the BenQ with a VIA card and DosFlash16
--------------------------------------------------
- connect a 2nd power supply unit to the BenQ, don't turn it on yet
- cold reboot or reset the computer
- boot from a Dos disk
- at the prompt type:
DosFlash r 7000 1 a0 1 4 A:\orig.bin and press return
- use the port your VIA card uses, 7000 is only an example
- keep in mind that the same VIA card may change the base address on another system
- DosFlash16 will ask you if you wanna resend the mtk vendor intro cmd, press Yes
- after you pressed Yes the changing drive status is shown on the screen
- turn on the BenQ and wait 2 or more seconds
- turn off the BenQ and wait 2 or more seconds
- turn on the BenQ, you should get a good drive status and flashing should start
- this worked only one time after the computer is powered on or resetted for me
- writing and erasing works the same way, for writing the flash type at the prompt:
DosFlash w 7000 1 a0 1 4 A:\ixtreme.bin
- for erasing type:
DosFlash e 7000 1 a0 1 4 D8 (D8 is the sector erase opcode for the BenQ flash, if you need
to erase another drive lookup the value in the datasheet or in DosFlash.typ
- in my tests the VIA did not work with any motherboard, it seems some Intel boards can kill
the VIA trick

Flashing the BenQ on a NForce board and DosFlash16
----------------------------------------------------
- power the BenQ up before, at the same time or after the computer, it doesn't really matter
- use DosFlash auto or manual mode, both will do the trick
- if DosFlash will ask you to resend the mtk vendor intro press Yes
- turn off and on the drive, wait 2 seconds in between
- the drive status will be displayed and should be good, if not power the drive off and on
once more
- you can now continue as usual using DosFlash
- erasing and writing the flash has worked for me on NForce4 motherboards
- if you use auto mode and the ports are scanned there is the possibility that you'll get the
resend question for other drives like a NEC, this is because the NEC has no MTK chip and
returns a bad status, if you know the NEC is at that port you should press No and press Yes
only if the port of the BenQ is shown
- this is so much easier than using the VIA, but at least the VIA should give more people a
cheap alternative to flash their drives and I bet most will already own this card

Flashing the BenQ with a VIA card or NForce board and DosFlash32
------------------------------------------------------------------
- connect a 2nd power supply unit to the BenQ, don't turn it on yet
- cold reboot or reset the computer
- turn the BenQ on when you are in Windows XP
- start DosFlash32
- DosFlash32 will ask you if you wanna resend the mtk vendor intro cmd, press Yes
- turn off the drive, wait 2 or more seconds, turn on the drive
- the flash should be recognized by DosFlash32 and you can use it as usual
- after closing DosFlash32 you can start it and use the power off/on trick again
- reading/writing/erasing were tested and worked for me without a prob